Dampcoarse Membrane (DPM) and Surface Primer 2 x coats in one day from €7.50 per sqm

porfil.®PLUS can be applied to all conventional concrete, mortar and screed surfaces. By applying porfil.®PLUS 2 to 4 days after installation of the concrete, mortar or screed surface, the conventional waiting time until covering of the surface can be carried out, is shortened to 3 to 5 days. The water-vapour-diffusion is reduced in such a degree that deformations due to one-sided drying-out are reduced.

For perfect bonding capabilities fire-dried silica sand is applied to the still wet porfil.®PLUS.

Application on floor-heating screeds saves the time consuming and costly heating program until the surface is ready for covering. After the tack-free drying of porfil.®PLUS the functional heating of the underfloor can be carried out. Following this, the floor can be covered with e.g. parquet, carpet, tiles…

Advantages:

• Very fast covering of concrete, mortar and screed surfaces only 3 to 5 days after installation of the surface
• Can be used under carpet floors, tiles, parquet, PVC, linoleum, coats of paint or other coatings
• No additional primer required
• Improvement of mechanical parameters (abrasion resistance and adhesive pull strength)
• Easy-to-clean surface (plasters, soilings, etc. can be easily removed)
• Very easy and fast application

The Problem-Solving DPM for coatings and coverings of all types porfil.®PLUS is the pore-filling and pressurised water resistant primer and sealant suitable to be applied under epoxy resins, polyurethanes, fillers, adhesives for coverings etc. For perfect bonding capabilities fire dried silica sand is applied to the still wet porfil.®PLUS. The application can be carried out, an absorbing surface assumed, down to temperatures of 8 degrees celsius. The certified feature of durability under the condition of continuous rear surface moisture ensures that no adhesion or cohesion damages occur.

Advantages:

• Barrier coefficient according to German standard TL NBM, roads made of concrete
• Reduction of plastic shrinking cracks due to early drying out
• No hydration suction required
• Application irrespective of the water-cement value (only requirement is an absorbing underground)
• Can be applied at temperatures down to +4 degrees celsius
• Fast covering or coating with appropriate paintings, coatings or covering adhesives
• Improvement of the mechanical parameters (abrasion resistance and adhesive pull strength)
• Resistant against chemicals, oil, grease, kerosene etc
• Protection of the underground against penetration of chlorides etc
• Discharge capacity according to German standard DIN IEC 61340, DIN 100015, DIN EN 1081-98, ASTM F 150-98

porfil.®BIT
Pore-filling sealant under bitumen sheetings
System-oriented special sealing material as pore-filling sealant and surface protection for bridges made of concrete, car parks and similar applications in relation with a thickening layer according to ZTV-ING, Part 7, section 1. porfil.®BIT is particularly appropriate for short treatment periods and low treatment temperatures. Due to its extreme low viscosity, porfil.®BIT has an excellent penetration ability in concrete and is therefore able to fill the pores and seal the concrete. The material consumption depends on the specific absorbency, roughness and humidity; application temperature and ambient temperature have also an influence on material consumption.

References:
Petrobras, Brazil; Metro BVG Berlin; German Railway AG; Siemens; Doriant Hotels and Resorts; Chatani, Tokyo, Japan; Rijkswaterstaat; Aquana GmbH; Audi AG; Toyota; ECE; Dubai Electricity and Water Authority; Burj Dubai Development; Ministry of Transport, Belgium.