Jointing Sand Stabiliser is a water miscible liquid which stabilises the joint filling sand used with concrete block paving, impeding the unwanted erosion of the sand and preventing ingress of water.

Application

• Joints should be full and the surface dry and swept clean
• Dilute 1 part solution to 6 parts clean tap water
• Spread over the entire paved area using either a watering can with fine rose or suitable spray equipment at a rate of 1 litre (diluted) to 7.5m² (5 litres undiluted makes 35 litres when diluted)
• It is recommended that Multicrete Jointing Sand Stabiliser should not be applied if heavy rain is expected within approx. 12 hours

Handling & Storage

Keep above the chemicals' freezing point to avoid rupturing the container. Keep container tightly closed. Do not use storage vessels or pipework made of aluminium, copper or its alloys.

First Aid Measures

Inhalation - May cause dizziness or headache. Remove to fresh air.
Ingestion - DO NOT induce vomiting. Get medical attention immediately.
Skin Contact - Rinse the skin immediately with lots of water. Get medical attention if irritation persists after washing.
Eye contact - Promptly wash eyes with plenty of water while lifting the eye lids. Get medical attention immediately. Continue to rinse.

Health & Safety Data Sheet available on request.

Jointing Sand Stabiliser should only be used on concrete block paving. It SHOULD NOT be used on concrete flags or clay pavers.